[Sunbeam Talbot Email List] stub axle bush

Mal Clark shadow74 at bigpond.com
Sun Jul 17 20:09:26 EDT 2011


Hi Bill,these bushes must be equal each side of the stub axle, you will find the protruding bush each side creates a area for the rubber grease seal to be located on. Can not see on your photo how you had seal on the non bush side. Mal Clark.
  ----- Original Message ----- 
  From: Bill M 
  To: Staowners 
  Sent: Sunday, July 17, 2011 11:27 PM
  Subject: [Sunbeam Talbot Email List] stub axle bush


  Hi guys, the right hand lower stub axle "eye" bush is worn so I am replacing it with a new kit from the Bamforths.


  As you can see in the attached photo, the old lower bush appears not to have been inserted far enough in so as to be equidistant from the stub axle sides. It is level with one edge but protruding on the other, whereas the upper bush is equally spaced. Is this correct or should it be further in like the upper bush ? I'm guessing in its current position the bush is affecting the Castor angle.



  From the manual, the new bush has to be pressed in from the rear so does that mean the old bush has to be pressed out to the rear too ? The manual description is a little confusing.


  thanks
  Bill


------------------------------------------------------------------------------


  _______________________________________________
  Staowners mailing list
  Staowners at sunbeamtalbot.info
  http://sunbeamtalbot.info/mailman/listinfo/staowners_sunbeamtalbot.info
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://sunbeamtalbot.info/pipermail/staowners_sunbeamtalbot.info/attachments/20110718/4f7e857c/attachment-0002.html>


More information about the Staowners mailing list