[Sunbeam Talbot Email List] George B Roberts, Philadelphia

[Bill Molloy]

Thanks Bob, looks like a nice job.

Are there any other manifolds that fit the ST heads 
other than the factory units ?

Would be nice to have more options re: carb choice

----- Original Message -----
From: Bob Hamilton <hamilton at accesswave.ca>
To: Bill Molloy <nqtraderman at yahoo.com>, staowners at sunbeamtalbot.info
Date: Wed, 27 Aug 2008 11:06:10 -0300
Subject: Re: [Sunbeam Talbot Email List] George B Roberts, Philadelphia

> Hi Bill,
> 
> I just happen to have images of George's SU setup. It was all hand made using aluminum tubing cut at an angle and welded together with flanges at both ends.
> 
> George's Address is (no email address I know of):
> 
> 429 West Allens Lane
> Philadelphia, PA  19119-2805
> 
> Phone No. (215) 242-8738
> 
> 
> 
> Regards,
> Bob
> 
> 
> At 10:46 AM 8/27/2008, Bill Molloy wrote:
> I have just read an article by George B Roberts, Philadelphia, USA
> in Practical Classics June 2008 where he discusses his MK11A Drophead.
> 
> Of particular interest, he mentions that he fitted it with "Twin HS6 SU" carbs.
> 
> If anyone knows him or has his contact details, I'd be interested to hear more
> about this conversion, particularly which inlet manifold he used.
> 
> 
>       
> 
> _______________________________________________
> Staowners mailing list
> Staowners at sunbeamtalbot.info
> http://sunbeamtalbot.info/mailman/listinfo/staowners_sunbeamtalbot.info  
> 
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> Robert (Bob) A.C. Hamilton, Waverley, Nova Scotia, Canada
> Sunbeam Talbots - Alpine, Drophead and Saloon, 1953-1954
> Sunbeam Talbot Web Page:  www.sunbeamtalbot.info (or .org)        
> E-Mail: hamilton at accesswave.ca or robertach at ns.sympatico.ca
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ 
>