[Sunbeam Talbot Email List] Chassis spacers

[Mal Clark]

Hi Bill,appears you have a big job ahead with your Alpine chassis,dont give up I have been there many times,I have found the spacers vary is size all along the chassis,so dont worry especially those rear ones,they can be seen when the body is back on,and you can judge the thickness then to take up the gap,but the others are important,to pull the body down squarely,aligning the twist is the body so as the door gaps etc line up,if your car had the thin spacers on the back,no doubt they will go back in the same position,good luck Mal Clark.
  ----- Original Message ----- 
  From: Bill Molloy 
  To: staowners at sunbeamtalbot.info 
  Sent: Sunday, July 06, 2008 4:29 AM
  Subject: [Sunbeam Talbot Email List] Chassis spacers


        am I right in thinking that the spacer that goes between the chassis and the rear body mounting is a thin alloy spacer as highlighted in Red in the attached photo ?



        or should it be thicker one similar to those under the floor ?



        Thanks

        Bill
       




------------------------------------------------------------------------------


  _______________________________________________
  Staowners mailing list
  Staowners at sunbeamtalbot.info
  http://sunbeamtalbot.info/mailman/listinfo/staowners_sunbeamtalbot.info
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://sunbeamtalbot.info/pipermail/staowners_sunbeamtalbot.info/attachments/20080706/4cab1c6b/attachment.html