[Staowners] power output

[Bob Hamilton]

Hi Mal,

Interesting thread and I wouldn't be too concerned considering it is 
a fresh rebuild and that at this point I would not recommend getting 
it to the 4300 rpm state until parts have worked in sufficiently.

Regards,
Bob


At 10:18 AM 5/5/2008, you wrote:
>Thanks everyone for replies on the Alpine engine output.Richard 
>explained it well, I thought it low considering what the engine has 
>had done to it, but keeping in mind it was Dyno'd at only 3000 
>rpm,peak power at 4200- 4400 rpm, I would hope that at those rev's 
>my engine would at least produce somewhere near as stated in manual, 
>other wise at lot of time and machining has been wasted,on the block 
>and cylinder head,I did a compression test today showing 135-140 psi 
>on all cylinders thanks again, Mal Clark.
>_______________________________________________
>Staowners mailing list
>Staowners at sunbeamtalbot.info
>http://sunbeamtalbot.info/mailman/listinfo/staowners_sunbeamtalbot.info

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Robert A.C. Hamilton, P.O. Box 5033, Waverley, Nova Scotia, B2R 1S2
E-Mail: hamilton at accesswave.ca or robertach at ns.sympatico.ca
Tel: 902-861-3277  Fax: 902-861-1361
Visit my 
<http://robertach.zenfolio.com/>Zenfolio<http://robertach.zenfolio.com/> 
Gallery and <http://www.accesswave.ca/~hamilton>Home Page
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://sunbeamtalbot.info/pipermail/staowners_sunbeamtalbot.info/attachments/20080505/5133dbe7/attachment.html